Homebrew Pinball #3, Part 3

Cross posted from the original Pinside thread, this is one of many posts regarding my third homebrew pinball machine, creatively nicknamed 'P3'

Attached the paper with thumb tacks. I wasn't able to get it as tight as I'd like, but I think it should be close enough.

I figure that once I actually get the holes drilled, etc, and every thing placed in a way that works, I'll have to strip the top of the playfield again, remove the paper (if it's survived), and then scan in the raw playfield again, and make a new CAD file based on the actual holes+positionings I ended up with

Posted Thursday, September 10, 2020
at 11:18 AM

Tags: Blog Post, Pinball, Project, P3,

blog comments powered by Disqus